Support     Downloads     About us      Contact us     Algeos Australia AUSTRALIA
ALGEOS
SPACER
Ordering Products
SPACER
Product Range
SPACER
Algeos Services
SPACER
Electronic Brochures
SPACER
Brochure Requests
SPACER
Support Zone
SPACER
Research Archive
SPACER
About Algeos
SPACER
Company News
SPACER
Follow us on Twitter
SPACER

FOOT HEALTHCARE

New at Algeos.com


  Alge-Cast last foam system
Back to: Website Index >> Product Range

Algeos' Polyurethane Last Foam is perfectly suited for producing lasts from negative casts. It is easy to work with and once it has hardened it can be sawn, nailed, tacked and polished.

ALGE-CAST is a two-part system which is mixed together before pouring into the mould. The best ambient temperature is about 20 degrees Celsius.



Directions of use

1. Take a clean, dry and heat resistant but pliable container.
2.
Mix 1 part of Foam to 1.1 parts of Hardener and stir with a wooden spatular for 20 seconds until the colour darkens and clears. Stop stirring. At this point the temperature rises.

3.

Pour into the mould and the solution will expand and set in the mould. (The setting time is about 140 seconds) Expansion is equal to 1.7 times.

It is useful to spray a silicone based release agent into the mould first!



Important:

Always wear protective gloves and masks. Skin contact is to be avoided and the foam must not be inhaled.




Algeos network: Algeos partners: UK sales: Australia sales:
DOT Foothealthcare.com DOT Orthotic Technicians DOT Podiatry DOT Podiatry
DOT Multicast DOT FIP DOT Orthotics & Prosthetics DOT Orthotics & Prosthetics
DOT Podotech DOT Interactive Biomechanics DOT Rehabilitation DOT Rehabilitation
DOT Diaped DOT Podiatry Arena DOT Footwear Materials DOT Footwear Materials
DOT 1st Phase Orthotics DOT FDUK DOT Shoe & Foot Sundries DOT Shoe & Foot Sundries

Copyright A. Algeo Ltd - All rights reserved.   Privacy l Contact Us l About Algeos
Questions relating to this website should be directed to Algeos Marketing Manager:  MAIL Marc Cameron